Operator's Manual
1.19 1.19
Specications
ALL FIGURES ARE NOMINALLY QUOTED AT THE RATED PTO SPEED OF 540 RPM UNLESS
OTHERWISE STATED.
Hydraulic System
Drive Type: PTO gearbox / twin tandem gear pumps
Hydraulic Oil Type: Refer to RECOMMENDED LUBRICANTS AND HYDRAULIC
FLUIDS
Tank Capacity: 133 Litres
Total System Capacity: 142 Litres
Suction Line Filtration: 125 micron no bypass mesh lter
Return Line Filtration: 10 micron with bypass check valve, 2 bar (29 psi)
Delivery Rate to Cutterheads: 29.5 Litres/min
Delivery Rate to Lift Controls: 15 Litres/min
Cleanliness Level: ISO Code 18/13 or better (ISO 4406)
1300 - 2500 Particles/ml <15µ
40 - 80 Particles/ml >15µ
Maximum Oil Temperature: 95 C (203 F)
Recommended Lubricants and Hydraulic Fluids
Grease Points: A good quality medium grease
Cutterhead Grease Points: A good quality medium grease
PTO Gearbox: EP90 gear oil.
Hydraulic System:
Ambient Temperature Range
0 - 30 C (32 - 86 F) 15 - 40 C (59 - 104 F)
ISO viscosity grade
46 hydraulic oil
ISO viscosity grade
68 hydraulic oil
Should you be in any doubt please contact your Toro dealer. Using incorrect grades will cause premature wear of
hydraulic components and invalidate warranty.
PTO Gearbox
Input: 540 rpm 1.3/8” 6 spline PTO shaft, anti-clockwise rotation (Looking on end of
shaft)
Capacity: 1 Litre. Refer to RECOMMENDED LUBRICANTS AND HYDRAULIC
FLUIDS
Output: 1862 rpm at pump coupling
SPECIFICATIONS