Operator's Manual

1.66 1.66

Every 250 Hours continued

Inspect the brakes shoes for wear: Remove the

wheel hubs and inspect the brake shoes. The shoes

must be replaced if the lining thickness is less than

1.5mm. Use genuine Toro replacement parts. Do

not reline brake shoes.

Inspect the brake wedges: Check that the brake

wedges operate the brake shoes correctly. Wedges

which are worn excessively will not apply the

brakes fully and must be replaced.

Examine the brake cables: Ensure that the brake

cables operate freely and that there are no signs of

fraying or other damage. Always replace damaged

cables.

Examine linkages: Ensure that all brake link-

ages are in good condition, operate freely and are

secured correctly. Lubricate pivot points with oil.

Examine cylinder: Check the brake cylinder and

the associated hydraulic hoses for leaks. Always

replace any leaking components.

Inspect the jockey wheel assembly: Examine the

wheel and tyre and ensure that they are in good

condition. Check that the jack is in good condi-

tion and operates freely. Replace worn or damaged

components.

Every 500 Hours

Perform routine checks: Refer to DAILY BE-

FORE USE, EVERY 50 HOURS AND EVERY

250 HOURS USE.

Thoroughly clean the machine.

Service the hydraulic system: Lower the cutter-

heads to the ground and drain the hydraulic oil by

removing the hydraulic tank drain plug. Remove

the oil tank ller ange to gain access to the strain-

er inside the tank. Unscrew and remove the strainer

and clean in parafn before replacing. Renew the

strainer if it is damaged.

Renew the return line oil lter element, refer to

RUNNING IN PERIOD - AT FIRST 50 HOURS

OF USE.

Replace the drain plug and rell the hydraulic

tank with new hydraulic oil, refer to SPECIFICA-

TIONS.

MAINTENANCE

1. Brake shoe

2. Spring