Operator's Manual
1.72 1.72
Cutterhead Bottom Blade Replacement
continued
The new bottom blade must be ground on its holder
prior to retting to the cutterhead. Adjust the cut-
ting cylinder position to give adequate clearance
for tting the new bottom blade holder. Ret the
bottom blade holder assembly to the cutterhead us-
ing the original xing bolts and tighten to a torque
of 35Nm (26 lbf.ft). Finally adjust the cylinder to
the bottom blade, refer to CUTTERHEAD CYL-
INDER TO BOTTOM BLADE ADJUSTMENT.
MAINTENANCE