Operator's Manual

1.42 1.42
MK3 200 mm (8˝) Fixed Cutterhead
Pivot knuckle xing: Secure the bolt in the
front “xed” hole position ‘A’ as shown.
Height of cut adjustment: The height of cut is
gauged by the position of the rear roller.
Turn the adjusting nut assembly ‘B’ both ends
clockwise to decrease height of cut ‘E’ or anti-
clockwise to increase height of cut ‘E’.
IMPORTANT: PREVENT DAMAGE - Do not
attempt to unlock the nut assemblies, ‘B’.
Ensure that all cutterheads are set at the same
height of cut by either referring to the indicator
rings ‘C’ or by using a height of cut gauge across
the full width of each cutterhead for greater ac-
curacy as shown.
MK3 254 mm (10˝) Fixed Cutterhead
Height of cut adjustment: The height of cut is
gauged by the position of the rear roller.
Turn the adjusting nut assembly ‘B’ both ends
clockwise to decrease height of cut ‘E’ or anti-
clockwise to increase height of cut ‘E’.
IMPORTANT: PREVENT DAMAGE - Do not
attempt to unlock the nut assemblies, ‘B’.
Ensure that all cutterheads are set at the same
height of cut by either referring to the indicator
rings ‘C’ or by using a height of cut gauge across
the full width of each cutterhead for greater ac-
curacy as shown.
OPERATING THE MOWER
B
E
C
E
=
B
E
C
E
=
A