Operator's Manual

1.43 1.43

MK3 200 mm (8˝) Floating Cutterhead

Pivot knuckle xing: Secure the bolt in the rear

‘oating’ slot position ‘A’ as shown.

Height of cut adjustment: The height of cut is

gauged by the position of the front and rear rollers.

To alter the rear roller position, turn the adjusting

nut assembly ‘B’ both ends clockwise to decrease

height of cut ‘E’ or anti-clockwise to increase

height of cut ‘E’.

IMPORTANT: PREVENT DAMAGE - Do not

attempt to unlock the nut assemblies, ‘B’.

To alter the front roller position loosen bolts ‘F’.

Release and turn adjusting nuts ‘D’ both ends

clockwise to increase the height of cut or anti-

clockwise to decrease the height of cut.

Ensure that all cutterheads are set at the same

height of cut by referring to the indicator rings ‘C’

or use the height of cut gauge across the full width

of each cutterhead as shown.

Tighten nuts ‘D’ and ‘F’ both ends.

OPERATING THE MOWER