Operator's Manual

1.39 1.39
Cutterhead Position Control
The cutterheads may be raised or lowered
independently using the bank of 3 lift control
levers.
To lower the cutterheads, operate the lift control
levers in a downward direction until locked into
position. If the cutterhead drive switch is in the
‘on’ position, the cylinder drive will engage when
the cutterheads are approximately 300mm (11.8)
above ground level.
IMPORTANT: PREVENT DAMAGE - The
lift control levers must be locked in position 1
while moving. NEVER mow with the lift control
levers in position 2 (neutral).
To raise the cutterheads, operate the lift control
levers in an upward direction and hold in
position 3. If the cutterhead drive switch is in the
‘on’ position, the cylinder drive will disengage
when the cutterheads are approximately 300mm
(11.8) above ground level. Release the lift control
levers when the cutterheads are at the required
height. The control levers will automatically return
to position 2 (neutral).
Dual Lift Conguration Control
The dual lift conguration control function enables
the lift controls to be used in two ways as follows:
Five gang mode, lift conguration 1:
Control switch in position 1
LH lift lever 3 controls LH wing cutterhead
Centre lift lever 4 controls LH front & centre & RH
front cutterheads
RH lift lever 5 controls RH wing cutterhead
Three / ve gang mode, lift conguration 2:
Control switch in position 2
LH lift lever 3 controls LH wing & LH front
cutterheads.
Centre lift lever 4 controls centre cutterhead
RH lift lever 5 controls RH wing & RH front
cutterheads.
With the LH and RH wing cutterheads locked in
the fully raised transport position.
Control switch in position 2
LH lift lever 3 controls LH front cutterhead
Centre lift lever 4 controls centre cutterhead
RH lift lever 5 controls RH front cutterhead
OPERATING THE MOWER
1. Down/oat
2. Neutral
3. Raise
4. LH wing or LH wing & LH front*
5. Centre & LH/RH front or centre*
6. RH wing or RH wing & RH front*
*Depending on which lift conguration is selected. Refer
to ‘dual lift conguration control’.
4 5 6
3
2
1
1. 5 gang mode
2. 3 / 5 gang mode
3. LH lift lever
4. Centre lift lever
5. RH lift lever
3
4 5
1
2