Operator's Manual

1.65 1.65
TROUBLE SHOOTING
FAULT POSSIBLE CAUSE REMEDY
Cutterdecks fail to start
up when lowered into
work
Faulty seat sensor switch Check mechanical and electrical operation
of switch
Low oil level Fill hydraulic oil reservoir to correct level
Faulty shut off sensor switch Check mechanical adjustment and electrical
operation
Pressure relief valve jammed open or
wrongly set
Have relief valve cleaned and pressure
checked. Consult your authorised dealer
Cutterblade jammed Free off as necessary
Cutterdeck control valve in the ‘off’ position
caused by:
- Defective control valve Overhaul control valve
- Electrical fault Have electrical system checked
Contact your Toro dealer if you have a problem which is not outlined above.