Operator's Manual

ThisproductcomplieswithallrelevantEuropean
directives.Fordetails,pleaseseetheDeclarationof
Incorporation(DOI)atthebackofthispublication.
Introduction
Readthisinformationcarefullytolearnhowtooperate
andmaintainyourproductproperlyandtoavoid
injuryandproductdamage.Youareresponsiblefor
operatingtheproductproperlyandsafely.
YoumaycontactT orodirectlyatwww.Toro.com
forproductsafetyandoperationtrainingmaterials,
accessoryinformation,helpndingadealer,orto
registeryourproduct.
Wheneveryouneedservice,genuineT oroparts,or
additionalinformation,contactanauthorizedToro
distributorandhavethemodelandserialnumbersof
yourproductready.Themodelandserialnumbers
arelocatedontheleftsideofthecuttingunit.Write
thenumbersinthespaceprovided.
ModelNo.
SerialNo.
Thismanualidentiespotentialhazardsandhas
safetymessagesidentiedbythesafety-alertsymbol
(Figure1),whichsignalsahazardthatmaycause
seriousinjuryordeathifyoudonotfollowthe
recommendedprecautions.
g000502
Figure1
1.Safety-alertsymbol
Thismanualuses2wordstohighlightinformation.
Importantcallsattentiontospecialmechanical
informationandNoteemphasizesgeneralinformation
worthyofspecialattention.
Contents
Safety.......................................................................3
SafetyandInstructionalDecals..........................3
Setup........................................................................4
1PreparingtheMachine.....................................4
2InspectingtheCuttingUnit...............................4
3ConvertingtheCuttingUnitfromLeftto
RightConguration.........................................4
4AdjustingtheHand-WheelAssemblies............5
5InstallingtheCuttingUnittothe
Machine..........................................................6
6LubricatingtheCuttingUnit..............................6
ProductOverview.....................................................7
Specications....................................................7
Attachments/Accessories...................................7
Operation..................................................................8
OperatingtheCuttingUnit..................................8
AdjustingthePivotKnuckle................................8
AdjustingtheHeightofCut.................................8
ClearingtheCuttingCylinders............................9
Maintenance...........................................................10
CheckingtheCuttingUnittoBedknife
Contact.........................................................10
GreasingtheCuttingUnit..................................10
CheckingtheRear-RollerBearing
Adjustment.....................................................11
CheckingRearRollerScraperWire
Tension..........................................................11
AdjustingtheContactBetweentheCylinder
andBottomBlade.........................................12
BacklappingtheCuttingUnit.............................13
GrindingtheCuttingUnit...................................13
ReplacingtheBottomBlade.............................14
©2017—TheToro®Company
8111LyndaleAvenueSouth
Bloomington,MN55420
2
Contactusatwww.Toro.com.
PrintedintheUK
AllRightsReserved