Operator's Manual

Issued: 21.01.13 Approved: Mod. No. 5078792 Sheet 2 of 10 Part No. 111-3991 (B)
SAFETY PRECAUTIONS
Decals
Serial label
Part No: Various
Location: Left hand end of the cutterhead.
WARNING - Danger of severing ngers or toes in cutting
mechanism
Part No: 40-13-010
Location: On the top of the cutterhead
WARNING - Height of cut adjustment
Part No: 63-13-039
Location: Wrapped around the height of cut adjusters
Fig 3
Before working on the machine it is essential that you read and understand the Safety Precautions as shown in the
Operator’s Manual.
Before working on the machine it is essential that :
- The engine is switched off.
- The parking brake is applied.
- There is no pressure in the hydraulic system.
- The cutterheads are fully down on the ground.
- Disconnect the battery terminals and ensure no contact is made between the terminals and machines metalwork.
WARNING: PREVENT ACCIDENTS - Take care to avoid the sharp edges of the cutting cylinder and bottom
blade when lifting or working on the cutterhead.
The cutterhead is heavy - It is recommended that suitable lifting equipment be used when removing the cutter-
head from the carton and during installation.
WARNING: ALWAYS SEEK PROFESSIONAL ADVICE FROM YOUR LOCAL AUTHORISED DEALER IF,
AFTER STUDYING THIS, YOU ARE UNSURE HOW TO FIT THIS KIT.
THIS SYMBOL MEANS BE ALERT! YOUR SAFETY IS INVOLVED.
EXERCISE GREAT CARE AND FOLLOW THE ADVICE GIVEN TO AVOID POTENTIAL
HAZARDOUS SITUATIONS
Fig 2
Fig 1