Operator's Manual
Issued: 08.09.10 Approved: Mod. No. 5059710 Sheet 1 of 6 Part No. 111-4034 (A)
Spellbrook, Bishop’s Stortford, Herts. CM23 4BU, England.
Telephone: 01279 723444 Fax: 01279 723821
E-mail: hayter.sales@toro.com / uk.service@toro.com Web: www.toro.com / www.hayter.co.uk
The Grooved Front Roller MK3 is designed for tment to the TORO MK3 Cutterhead. The Grooved Front Roller Mk3 can be
tted with a 4, 6, 8 or 10 bladed cutting cylinder (200mm diameter). The way in which this unit is operated and maintained will
have a profound effect on performance and reliability.
The Grooved Front Roller MK3 should not be tted to any other machines than those stated above.
This instruction sheet should be regarded as part of the machine, as it gives essential information regarding machine
safety, specications, assembly and maintenance.
For all other information refer to your Operator’s Manual and Parts List.
In pursuit of continuous product development, TORO reserve the right to alter specications without notice.
Left and Right: Throughout this instruction sheet refers to the mower when looking in the direction of forward travel.
FITTING AND OPERATION INSTRUCTION SHEET
GROOVED FRONT ROLLER MK3
Model 02823
For Cutterhead Models 02800, 02801, 02802 and 02803
ORIGINAL VERSION (EN)
Serial No. From 310000001
INTRODUCTION
CONTENTS
Contents Page No.
Introduction 1
Safety precautions 2
Delivery Checklist 2 - 3
Specications & Weights 3
Assembly 4
Floating MK3 Cutterhead 5
Warranty 6