Form No. 3384-255 Rev A Mauser KS-534 Full Safety Cab Kit CT2120/CT2140/CT2240/LT3340 and Groundsmaster® 3400 Mowers Model No. 02890—Serial No. 314000001 and Up Register at www.Toro.com.
This product complies with all relevant European directives, for details please see the separate product specific Declaration of Conformity (DOC) sheet. Figure 2 1. Safety alert symbol Introduction This manual uses 2 other words to highlight information. Important calls attention to special mechanical information and Note emphasizes general information worthy of special attention. This manual provides instructions for the operation and operator maintenance of the Full Safety Cab.
Safety WARNING Prevent Accidents WARNING Before working on the machines electrical systems, ALWAYS disconnect the battery terminals (negative terminal first) and ensure no contact is made between the terminals and the machines metalwork. Before working on the machine it is essential that: • The engine is switched off. • The parking brake is applied. Important: Always wear the seat belt when the safety cab is fitted. • There is no pressure in the hydraulic system.
Max Slope Angles of Mowers with Cab CT2140 Model 30656, CT2240 Model 30654 & GM 3400 Model 30651 Part No. 111-1530 This cab can be fitted to the mowers listed at the front of this document. When fitted with a cab, each mower model will have a different maximum slope angle and this will be stated on the decal located on the lid of the storage pod on the left of the machine. See Figure 4 through Figure 6 for the correct Maximum Slope angle decal for your machine when fitted with a cab.
Noise Level Sound Pressure Level Operator’s Daily Personal Noise Exposure: TORO has no control over site conditions, duration of use, degree of cab doors/windows, state of maintenance or adjustment of the mower. All of these factors will affect the operators daily personal exposure level. Models CT2120, CT2140 & CT2240 These units have a sound pressure level at the operator’s ear of 83 dBA, which includes an Uncertainty Value (K) of 1 dBA.
Interior Light Switch Product Overview Press the front of the interior light switch (Figure 9) to turn on the light. Press the rear of the switch to turn off the light. Controls Heater/Blower Controls The controls are mounted on the right side in the roof lining. 2 1 Figure 9 1. Interior light switch Front Widow Handle (2) The front window can be opened for ventilation. There are two handles (Figure 10). 1 g020347 Figure 7 1. Blower speed switch 3.
Rear Window Handle and Prop The rear window can be opened for ventilation. Rotate the rear window prop to hold the window open (Figure 11). Figure 11 1. Rear window handle 2.
Operation WARNING If you operate your machine in temperatures below 5 degrees C (40 degrees F), use washer fluid with antifreeze protection. Failure to use washer fluid with antifreeze protection in cold weather could result in impaired windscreen vision and increase the risk of injury or accident. Note: Determine the left and right sides of the machine from the normal operating position. Operating the Heating System 1. Set the air conditioner switch to OFF. 2.
To open the door from inside the cab, pull back on the door lock release lever while opening the door (Figure 14). Figure 14 1. Door lock 2. Release lever Adjusting the Mirrors While the sitting in the seat, have a helper adjust the side view mirrors to attain the best view around the side of the machine (Figure 15). 1 g020380 Figure 15 1.
Maintenance 4. Once the cab has been fully raised, install the safety support bracket as follows: • Remove the safety support bracket from the WARNING storage pod. Prevent Accidents • Using either of the two cross beam brackets, place the safety support bracket within the cross beam brackets and insert the appropriate locking lever through both brackets and rotate downwards.
Figure 18 1. Cab fuse block Washing the Machine and Cab When washing the machine and the cab, Do Not direct water into the roof area.
Notes: 12
Notes: 13
Notes: 14
International Distributor List Distributor: Agrolanc Kft Balama Prima Engineering Equip. B-Ray Corporation Casco Sales Company Ceres S.A. CSSC Turf Equipment (pvt) Ltd. Cyril Johnston & Co. Cyril Johnston & Co. Equiver Femco S.A. ForGarder OU G.Y.K. Company Ltd. Geomechaniki of Athens Golf international Turizm Guandong Golden Star Hako Ground and Garden Hako Ground and Garden Hayter Limited (U.K.) Hydroturf Int. Co Dubai Hydroturf Egypt LLC Irrimac Irrigation Products Int'l Pvt Ltd. Jean Heybroek b.v.
The Toro Total Coverage Guarantee A Limited Warranty Conditions and Products Covered The Toro® Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).
