Form No. 3373-483 Rev A Mauser KS-534 Full Safety Cab Kit CT2120/CT2140/LT3340 and Groundsmaster® 3400-D Mowers Model No. 02890—Serial No. 312000001 and Up To register your product or download an Operator's Manual or Parts Catalog at no charge, go to www.Toro.com.
This product complies with all relevant European directives, for details please see the separate product specific Declaration of Conformity (DOC) sheet. This manual identifies potential hazards and has safety messages identified by the safety alert symbol (Figure 2), which signals a hazard that may cause serious injury or death if you do not follow the recommended precautions. Introduction This manual provides instructions for the operation and operator maintenance of the Full Safety Cab. Figure 2 1.
Safety CT2120 Model 30655 Part No. 111-5960 WARNING Maximum Slope angle 13 degrees Before working on the machine it is essential that: • The engine is switched off. • The parking brake is applied. • There is no pressure in the hydraulic system. • The cutting units are fully down on the ground. WARNING Prevent Accidents When carrying out maintenance operations always use the appropriate personal protection equipment.
LT3340 Model 30657 Sound Pressure Level Part No. 111-1530 Models CT2120 & CT2140 Maximum Slope angle 16 degrees These units have a sound pressure level at the operator’s ear of 83 dBA, which includes an Uncertainty Value (K) of 1 dBA. Sound pressure level was determined according to the procedures outlined in EN 836. Model LT3340 This unit has a sound pressure level at the operator’s ear of 80 dBA, which includes an Uncertainty Value (K) of 1 dBA.
Product Overview Interior Light Switch Controls Press the front of the interior light switch (Figure 8) to turn on the light. Press the rear of the switch to turn off the light. Heater/Blower Controls The controls are mounted on the right side in the roof lining. 2 1 Figure 8 1. Interior light switch Front Widow Handle (2) The front window can be opened for ventilation. There are two handles (Figure 9). 1 g020347 Figure 6 1. Blower speed switch 3.
Rear Window Handle and Prop The rear window can be opened for ventilation. Rotate the rear window prop to hold the window open (Figure 10). Figure 10 1. Rear window handle 2.
Operation WARNING If you operate your machine in temperatures below 5 degrees C (40 degrees F), use washer fluid with antifreeze protection. Failure to use washer fluid with antifreeze protection in cold weather could result in impaired windscreen vision and increase the risk of injury or accident. Note: Determine the left and right sides of the machine from the normal operating position. Operating the Heating System 1. Set the air conditioner switch to OFF. Operating the Windows 2.
To open the door from inside the cab, pull back on the door lock release lever while opening the door (Figure 13). Figure 13 1. Door lock 2. Release lever Adjusting the Mirrors While the sitting in the seat, have a helper adjust the side view mirrors to attain the best view around the side of the machine (Figure 14). 1 g020380 Figure 14 1.
Maintenance 2. With the levers in the vertical position (Figure 15), push them through the sets of brackets. It might be necessary to wriggle the levers into the brackets to align the locking pegs in the slots. Important: Maintenance or repairs, on the heating system, should be carried out by a Toro dealer or a specialist in vehicle heating systems. 3. When the levers are fully inserted, rotate them backwards to lock them in position (Figure 16).
Schematics g018438 1 Front screen wiper and washer switch 2 Beacon switch (when beacon kit fitted) 3 Three position switch for Blower speed 4 Blower motor 5 Front screen wiper motor 6 Front screen washer pump 7 Main relay 8 Interior light and switch 9 Beacon (when beacon kit fitted) Electrical Circuit Diagram (Rev.
Intl Dist List Distributor: Atlantis Su ve Sulama Sisstemleri Lt Balama Prima Engineering Equip. B-Ray Corporation Casco Sales Company Ceres S.A. CSSC Turf Equipment (pvt) Ltd. Cyril Johnston & Co. Equiver Femco S.A. G.Y.K. Company Ltd. Geomechaniki of Athens Guandong Golden Star Hako Ground and Garden Hako Ground and Garden Hayter Limited (U.K.) Hydroturf Int. Co Dubai Hydroturf Egypt LLC Irriamc Irrigation Products Int'l Pvt Ltd. Jean Heybroek b.v. Maquiver S.A. Maruyama Mfg. Co. Inc.
The Toro Total Coverage Guarantee A Limited Warranty Conditions and Products Covered The Toro® Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).
