Operator's Manual

ManualsBrandsToro ManualsAttachmentsFlashing Beacon Kit, CT or LT Series Turf Mowers

Issued: 19.04.12 Approved: Mod. No. 5073024 Sheet 1 of 6 Part No. 111-3768 (C)

Spellbrook, Bishop’s Stortford, Herts. CM23 4BU, England.

Telephone: 01279 723444 Fax: 01279 723821 E-mail: sales@hayter.co.uk

Service@hayter.co.uk Web: www.toro.com / www.hayter.co.uk

This kit provides a ashing amber warning beacon and is suitable for the listed machines only.

These instructions should be considered as part of the machine, as it gives essential information regarding machine

safety, operation, maintenance and specications.

For all other information refer to your Operator’s Manual and Parts List.

In pursuit of continuous product development, TORO reserve the right to alter specications without notice.

Left and Right : Throughout this manual refers to the mower when looking in the direction of forward travel.

FITTING AND OPERATION INSTRUCTION SHEET

FLASHING BEACON KIT MODEL 02901

For CT2120, CT2140, LT3340 & GM3400

Models 30655, 30656, 30657 & 30651

ORIGINAL VERSION (EN)

FROM SERIAL NO 312000001

INTRODUCTION

CONTENTS

Contents Page No.

Introduction 1

Safety precautions 2

Specications 2

Delivery Checklist 2

Delivery Checklist Exploded Diagram 3

Fitting instructions 3 - 4

Operating Instructions 5

Maintenance 5

Notes 5

Warranty 6

Summary of content (6 pages)

PAGE 1
Spellbrook, Bishop’s Stortford, Herts. CM23 4BU, England. Telephone: 01279 723444 Fax: 01279 723821 E-mail: sales@hayter.co.uk Service@hayter.co.uk Web: www.toro.com / www.hayter.co.uk FITTING AND OPERATION INSTRUCTION SHEET FLASHING BEACON KIT MODEL 02901 For CT2120, CT2140, LT3340 & GM3400 Models 30655, 30656, 30657 & 30651 ORIGINAL VERSION (EN) FROM SERIAL NO 312000001 CONTENTS Contents Page No.
PAGE 2
SAFETY PRECAUTIONS THIS SYMBOL MEANS BE ALERT! YOUR SAFETY IS INVOLVED. EXERCISE GREAT CARE AND FOLLOW THE ADVICE GIVEN TO AVOID POTENTIAL HAZARDOUS SITUATIONS Before working on the machine it is essential that you read and understand the Safety Precautions as shown in the Operator’s Manual. Before working on the machine it is essential that : - The engine is switched off. - The parking brake is applied. - There is no pressure in the hydraulic system. - The cutterheads are fully down on the ground.
PAGE 3
DELIVERY CHECKLIST EXPLODED VIEW Fig 1 3 C D 2 E E 5 8 7 6 1 FITTING INSTRUCTIONS The beacon attaches on the inside of the right hand ROPS post and uses an existing bolt hole in the ROPS. 1. Open the engine cover. 2. Disconnect the negative cable from the battery. 3. Remove the bulkhead to enable access to the main wiring loom by removing the four M6 screws. 4. Ensure that the ROPS pivot bolts and clamp bolts are in place and are tight. Refer to Fig 3. 5.
PAGE 4
FITTING INSTRUCTIONS Continued 6. Align the hole in the beacon bracket (item 1) with this hole and insert the new bolt (item 5) and washer (retained from step 5). Refer to Fig 3. 7. Fit the new nut (item 7) and washer (retained from step 5), tighten to a torque of 15Nm. Do not overtighten as this will make the ROPS difficult to fold. Refer to Fig 3. 8. Fit the beacon stand (item 2) to the beacon bracket (item 1). Refer to Fig 3. 9. Fig 3 3 C E 5 7 6 1 11.
PAGE 5
OPERATING INSTRUCTIONS The beacon is powered when the ignition is turned to position 1 and the beacon switch is operated. Fig 6 Fig 7 Beacon Symbol Depress bottom of the switch to activate the beacon. MAINTENANCE Clean the beacon with a moist clean cloth. The beacon fuse is located in the machines fuse box. It is a 10 Amp fuse situated in the third position from the right. Fig 8 Fuse Box Cover 10 amp Fuse NOTES Issued: 19.04.12 Approved: Mod. No. 5073024 Sheet 5 of 6 Part No.
PAGE 6
WARRANTY The Toro Total Coverage Guarantee A Limited Warranty • Conditions and Products Covered Toro® The Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).