Operator's Manual

Issued: 10.02.12 Approved: Mod. No. 5071851 Sheet 3 of 4 Part No. 111-3773 (B)
1
2
2
3
3
Fig 1
FITTING INSTRUCTIONS
For instructions on folding the ROPS refer to the Operator’s Manual, section titled Folding the ROPS.
This ROPS assist kit reduces the effort required to raise and to lower the ROPS by hand only.
WARNING: PREVENT ACCIDENTS - The gas springs contain stored energy when compressed. Do not attempt
to remove the gas springs unless the ROPS is in its fully raised position. Do not attempt to dismantle the gas spring
as it contains internal pressure even when fully extended.
OPERATING INSTRUCTIONS
1. Fit one gas spring (item 1) to each side of the ROPS frame
using the M8 setscrews (item 2) and nylon insert nuts (item
3) supplied. Tighten to a torque of 28Nm.
2. The gas springs must be mounted with the rod end pointing
downwards as shown. Failure to mount the gas springs this
way could reduce their life.
3. Fix the serial label adjacent to the machine serial label.
Fig 2
2 & 3
1
2 & 3
DELIVERY PARTS LIST