Operator's Manual

ManualsBrandsToro ManualsAttachmentsCleated Tyres Kit, CT Series Turf Mowers

Issued: 23.02.12 Approved: Mod. No. 5071851 Sheet 1 of 4 Part No. 111-4080 (B)

Spellbrook, Bishop’s Stortford, Herts. CM23 4BU, England.

Telephone: 01279 723444 Fax: 01279 723821

E-mail: hayter.sales@toro.com / uk.service@toro.com Web: www.toro.com / www.hayter.co.uk

This kit provides a set of lugged front and rear tyres for increased grip and durability.

This is suitable for the CT2120/2140 only.

This instruction sheet should be regarded as part of the machine, as it gives essential information regarding machine

safety, speciﬁcations, assembly, maintenance and warranty.

For all other information refer to your Operator’s Manual and Parts List.

In pursuit of continuous product development, TORO reserve the right to alter speciﬁcations without notice.

Left and Right : Throughout this manual refers to the mower when looking in the direction of forward travel.

FITTING AND OPERATION INSTRUCTION SHEET

CLEATED TYRE KIT MODEL 02913

For CT2120 & CT2140

Models 30655 & 30656

ORIGINAL VERSION (EN)

FROM SERIAL NO 312000001

INTRODUCTION

Contents Page No.

Introduction 1

Safety precautions 2

Speciﬁcations 2

Delivery checklist & diagram 2

Fittings instructions 3

Operating instructions 3

Maintenance 3

Spare Parts 3

Warranty 4

CONTENTS

Summary of content (4 pages)

PAGE 1
Spellbrook, Bishop’s Stortford, Herts. CM23 4BU, England. Telephone: 01279 723444 Fax: 01279 723821 E-mail: hayter.sales@toro.com / uk.service@toro.com Web: www.toro.com / www.hayter.co.uk FITTING AND OPERATION INSTRUCTION SHEET CLEATED TYRE KIT MODEL 02913 For CT2120 & CT2140 Models 30655 & 30656 ORIGINAL VERSION (EN) FROM SERIAL NO 312000001 CONTENTS Contents Page No.
PAGE 2
SAFETY PRECAUTIONS THIS SYMBOL MEANS BE ALERT! YOUR SAFETY IS INVOLVED. EXERCISE GREAT CARE AND FOLLOW THE ADVICE GIVEN TO AVOID POTENTIAL HAZARDOUS SITUATIONS Before working on the machine it is essential that you read and understand the Safety Precautions as shown in the Operator’s Manual. Before working on the machine it is essential that : - The engine is switched off. - The parking brake is applied. - There is no pressure in the hydraulic system. - The cutterheads are fully down on the ground.
PAGE 3
FITTING INSTRUCTIONS WARNING: PREVENT ACCIDENTS - Refer to the Operators Manual for guidance on Raising the Mower off the ground. 1. Loosen the wheel nuts. 2. Raise the mower off the ground sufficiently to allow removal of the wheels. 3. Remove the existing wheels. 4. Fit the new wheel assemblies and refit the wheel nuts. 5. Lower the mower to the ground. 6. On the front wheels, tighten the wheel nuts to 200Nm. 7. On the rear wheels tighten the wheel nuts to 54Nm. 8.
PAGE 4
WARRANTY The Toro Total Coverage Guarantee A Limited Warranty • Conditions and Products Covered Toro® The Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).