Installation Instructions

Issued: 25.03.14 Approved: Mod. No. Sheet 11 of 14 Part No. 111-5560 (B)
BLACK
RED / WHITE
GREEN
BLUE
VIEW ON CABLE ENTRY
VIEW ON CABLE ENTRY
BLACK
BLUE
BLACK
GREEN
BLACK
RED/WHITE
FRONT MARKER
FRONT INDICATOR
HEADLAMP
BLACK
BLACK
BLACK
BLUE
GREEN
RED / WHITE
ITEM 16
Fig 9
FITTING INSTRUCTIONS FRONT LIGHTS - ALL MODELS Continued
14. The cables must now be connected to the main wiring loom of
the machine and this is done with a connector lead (item 16).
It is important that the following connections are correctly
carried out. Refer to Fig 9.
15. Pass the connector lead through the hole in front of the chassis
towards the cutter manifold and locate the two connectors on
the main wiring loom.
16. Plug the cables into these connectors.
Instrument Panel Switches
17.
Now the switches must be put into the control panel and
connected to the main wiring loom.
18. Remove the six screws fi xing the control panel to the control
pod.
19. Carefully lift off the panel ensuring that the connectors to the
existing switches are not disturbed.
20. Feed the longest end of the connector lead (item 30) down the
control arm.
Refer to Fig 10.
Connect to the multi-pin plug on the main harness at the base of
the control arm.
21. In the rear face of the control pod, just above the key switch,
are switch blank panels beside the auto limited lift and beacon
switches. Refer to Fig 11.
22. Remove these and push the connectors and wires through the
switch holes. Connect the light and hazard switch referring to
the labels on the connectors identifying them.
LIMITED
LIFT
LIGHTS
HAZARD
BEACON
Fig 10
Fig 11
CONNECTOR LEAD
INSTRUMENT PANEL
INDICATOR SWITCH
LIGHT
SWITCH
HAZARD
SWITCH
CONTROL POD
CONTROL ARM
PLUG INTO
MAIN HARNESS