Installation Instructions

Issued: 25.03.14 Approved: Mod. No. Sheet 6 of 14 Part No. 111-5560 (B)
15. Take three M5*20 setscrews (item 9) and place an M5 washer
(item 8) on each.
16. Take the red stop/tail light (item 5) and pass the screws through
the three lugs on its base.
17. Put these three screws through the three holes in the upper light
mounting position so that the red stop/tail lamp is mounted on
the rear face with the screws pointing through on the front face.
18.
Place the M5 plain washer (item 8) and an M5 nyloc nut
(item 31) on these three screws.
19.
Repeat this procedure for the amber rear direction indicator
(without heat sink) (item 4).
20.
Now tighten all fi xings including the centre one holding the
rear refl ector.
21.
Feed all electrical cables down the front of the ROPS frame
and onto the electrical mount panel.
22.
The cables must now be connected to the main wiring
loom of the machine and this is done with a connector lead
(item 23). It is important that the following connections are
correctly made. Refer to Fig 3.
23.
Fit the 10 and 15 amp fuses (items 25 & 26) as shown. Refer
to Fig 4.
VIEW ON CABLE ENTRY
BLACK
RED
BLACK
RED
BLACK
GREEN
BLACK
GREEN
BLACK
RED
ORANGE
BLANK
BLANK
NUMBER
PLATE
INDICATOR
STOP/TAIL
WHITE
RED
GREEN
BLACK
RED
VIEW ON CABLE ENTRY
WHITE
BROWN
CONNECTOR
LEAD
PLUGS INTO
MAIN HARNESS
Fig 3
10101010 15
Fig 4
FITTING INSTRUCTIONS REAR LIGHTS - ALL MODELS Continued