Installation Instructions

g018241
1
2
3
4
5
2
Figure2
1.Bolt,M16x110mm
4.Left,rearlightbracket
2.Existingwashers5.Nut,M16
3.Orangeindicatorsideup
7.InstallthenewM16nutontotheboltandtorqueit
to15N-m(11ft-lb).
Note:Donotovertightenitasthiswillmakethe
ROPSdifculttofold.
8.RemovetheROPSpivotboltontherightsideofthe
mower.
9.Aligntheupperholeintheright,rearlightbracketwith
theholeintheROPSandinsertthenewM16x110mm
bolt,usingtheexistingwashers(Figure3).
g018242
1
2
3
4
5
2
Figure3
1.Nut,M16
4.Orangeindicatorsideup
2.Existingwashers5.Bolt,M16x110mm
3.R.H.rearlightbracket
10.InstallthenewM16nutontotheboltandtorqueit
to15N-m(11ft-lb).
Note:Donotovertightenitasthiswillmakethe
ROPSdifculttofold.
Note:Ifthereisalreadyabeaconkitttedtotheright
sideorawastebinkitttedtoleftside,usetheexisting
boltandthenewM16nylocnutsprovidedwiththiskit.
11.FeedallelectricalcablesdownthefrontoftheROPS
frameandontotheelectricalmountpanel.
12.Connectthecablestothemainwiringharnessofthe
machinewhichislocatedontheelectricalbulkhead
(Figure4),asfollows:
A.Connectthe4-pin,left,rear,light-assembly,wiring
connectortothecorresponding4-pin,electrical
connectorontheleftsideofthemainwiring
harness.
B.Connectthe4-pin,right,rear,light-assembly,
wiringconnectortothecorresponding4-pin
electricalconnectorontherightsideofthemain
wiringharness.
Note:The2-pinelectricalconnectorsontheleft
andright,rear,lightassemblyisrequiredforthe
number-platelight.Onlyoneofthe2-Pinelectrical
connectorsisused.
g018243
1
2
3
Figure4
1.4-pin,left,rear,
light-assemblyconnector
onthemainwiringharness
3.4-pin,left,rear,
light-assemblyconnector
onthemainwiringharness
2.3-pin,
electrical-pressure-switch,
cableconnectoronthe
mainwiringharness
13.Install2fuses(15amp)intothefuseblock.Usethe
rstandthirdreceptaclesfromtheleftendofthefuse
block(Figure5).
3