Installation Instructions

FormNo.3430-762RevA

TUV25KPHSpeedDecalKit

ModelNo.02990

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine(fortheProLineH800RotaryMower).

Speeddecalsign

Aluminiumplate1

Setscrew(M6x30mm)

Washer(1/4inch)

Locknut(M6)

Capnut(M6)

Installthespeeddecalkit(fortheProLineH800Rotary

Mower).

Nopartsrequired

–

Preparethemachine(forallothermachines).

PVCsign

Aluminiumsign1

Spacer(1/2x15mm)

Washer(1/4inch)

Locknut(M6)

Setscrew(M6x30mm)

Capnut(M6)

Rivet(3/16x5/8inch)

Installthespeeddecalkit(forallothermachines).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheEU

AllRightsReserved

*3430-762*A

PAGE 1
Form No. 3430-762 Rev A TUV 25KPH Speed Decal Kit Model No. 02990 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. Use No parts required – Prepare the machine (for the ProLine H800 Rotary Mower). Speed decal sign Aluminium plate Set screw (M6 x 30 mm) Washer (1/4 inch) Locknut (M6) Cap nut (M6) 2 1 2 2 2 2 Install the speed decal kit (for the ProLine H800 Rotary Mower).
PAGE 2
Prepare the Machine 3. On the aluminium plate, locate the center of the plate vertically and horizontally (Figure 2). For the ProLine H800 Rotary Mower 4. From the center of the plate, measure 77 mm (3 inches) to the left and right (Figure 2). 5. From the locations measured in step 4, measure up 25 mm (1 inch) and drill 2 holes (5 mm or 3/16 inch) into the plate (Figure 2). 1. Park the machine on a level surface. 2. Engage the parking brake. 3. Lower the cutting units and the hopper. 4.
PAGE 3
g283317 Figure 2 3
PAGE 4
6. Prepare the Machine Using the existing holes in the rear bumper, install the aluminium plate to the rear bumper using 2 set screws (M6 x 30 mm), 2 washers (1/4 inch), 2 locknuts (M6), and 2 cap nuts (M6) as shown in Figure 3. For All Other Machines 1. Park the machine on a level surface. 2. Engage the parking brake. 3. Shut off the engine and remove the key. Installing the Speed Decal Kit For All Other Machines Install per local codes. g283318 Figure 3 1. Rear bumper 4. Locknut (M6) 2.