Operator's Manual

g353110
Figure16
1.Carriagebolt(3/8x2-1/4
inches)
4.Link(cuttingunit)
2.Plate(rearcarrierframe)5.Flangelocknut(3/8inch)
3.Washer
2.Alignawasherbetweenthecarrierplateand
link(Figure16),andlooselyassembletheplates
andspacerwithacarriagebolt(3/8x2-1/4
inches),washer,andangelocknut(3/8inch).
Note:Ifyouarestartingassemblyatthebackof
thecuttingunit,usethemiddleholeoftheplate.
3.Repeatstep2attheotherplateholesandlinks.
4.Torquetheangelocknutsto37to45N∙m(27
to33ft-lb).
AssemblingtheCarrierFramesfor
theFrontCuttingUnits
CuttingUnitwithMountingPlates
Note:Thefrontcarrierframesarepartoftheoptional
liftarmkit.
1.Aligntheholesintheplatesofthefront-carrier
framewiththeholesinthecuttingunitmounting
plates(Figure17).
g353163
Figure17
1.Pivottube(front-carrier
frame)
4.Spacer
2.Carriagebolt(3/8x1-1/4
inches)
5.Mountingplate(cutting
unit)
3.Plate(frontcarrierframe)6.Flangelocknut(3/8inch)
2.Alignaspacerbetweenthecarrierplate
andmountingplate(Figure17),andloosely
assembletheplatesandspacerwithacarriage
bolt(3/8x1-1/4inches)andangelocknut(3/8
inch).
Note:Ifyouarestartingassemblyattheback
ofthecuttingunit,usethemiddleholesofeach
plate.
3.Repeatstep2attheotherplateholes.
4.Torquetheangelocknutsto37to45N∙m(27
to33ft-lb).
5.Repeatsteps1through4fortheotherfront
cuttingunitandcarrierframe.
AssemblingtheCuttingUnitand
RearCarrierFrame
CuttingUnitwithMountingPlates
Note:Therearcarrierframeispartoftheoptional
liftarmkit.
1.Aligntheholesintheplatesoftherear-carrier
framewiththeholesinthecuttingunitmounting
plates(Figure13).
18