Operator's Manual

g011218
Figure21
1.Tipperchain
8
InstallingtheCuttingUnit
DriveMotors
NoPartsRequired
Procedure
1.Positionthecuttingunitsinfrontoftheliftarm
pivotrods.
2.RemovetheweightandO-ring(Figure22)from
theinsideendoftherightcuttingunit.
g011964
Figure22
1.O-ring
3.Mountingbolts
2.Weight
3.Removetheplugfromthebearinghousingon
theoutsideendoftherightcuttingunitand
installtheweightsandgasket.
4.Removetheshippingplugfromthebearing
housingsontheremainingcuttingunits.
5.InserttheO-ring(suppliedwiththecuttingunit)
ontheangeofthedrivemotor(Figure23).
g012025
Figure23
1.O-ring
2.Reelmotor
6.Mountthemotortothedriveendofthecutting
unit,andsecureitwith2capscrewsprovided
withcuttingunit(Figure23).
9
AdjustingtheLiftArms
NoPartsRequired
CheckingLiftArmandRear
CuttingUnitClearance
1.Starttheengine.
2.Raisethecuttingunits.
3.Atthefrontcuttingunits,measurethedistance
betweentheleftliftarmandtheoorplate
bracket,andtherightliftarmandtheoorplate
bracket(Figure24).
Note:Thecorrectclearanceis5to8mm(3/16
to5/16inch).Iftheclearanceisnotinthis
range,adjustthecuttingunitliftcylinder;refer
20