Installation Instructions
Table Of Contents
- .
- 1 Preparing the Machine
- 2 Mounting the Roller Bumper
- 3 Mounting the Hydro Guard
- 4 Installing the Basket Mounting Assemblies
- 5 Installing the Cut-off Bar
- 6 Installing the New Grass Deflector(Front Cutting Units Only)
- 7 Removing the Support Tube
- 8 Assembling the Rear Grass Basket
- 9 Mounting the Baskets to the Cutting Units
- 10 Adjusting the Front Basket Position
- 11 Adjusting the Rear Basket Position
- 12 Adjusting the Rear Basket Lip Bracket
- 13 Adjusting the Rear Grass Shield
- 14 Adjusting the Roller Bumper
ProcedureDescription
Qty.
Use
10
Nopartsrequired
–
Adjustthefrontbasketposition.
11
Nopartsrequired
–
Adjusttherearbasketposition.
12
Nopartsrequired
–
Adjusttherearbasketlipbracket.
13
Nopartsrequired
–
Adjustthereargrassshield.
14
Nopartsrequired
–
Adjusttherollerbumper.
Note:The27inchrearrollerbrushkit(Model03186),willnotworkwiththereargrassbasketontheReelmaster3100
GrassBasketKit(Model03185).TherearcuttingunitcanbettedwiththeRearRollerScraperKit(PartNo.114-9368)in
placeoftherearrollerbrushkit.
1
PreparingtheMachine
NoPartsRequired
Procedure
1.Parkthemachineonalevelsurface.
2.Engagetheparkingbrake.
3.Shutofftheengine,andremovethekey.
2
MountingtheRollerBumper
Partsneededforthisprocedure:
1Rollerbumper
2
Flange-headscrews(8x16mm)
Procedure
Mounttherollerbumpertotheengineangewith2
ange-headscrews(8x16mm);refertoFigure1.
g012214
Figure1
1.Rollerbumper2.Engine
3
MountingtheHydroGuard
Partsneededforthisprocedure:
1Hydroguard
1
Bolt(5/16x1inch)
Procedure
1.Removetheboltandnutsecuringthelowerendofthe
cablesupportbrackettothepumpplate(Figure2).
Discardtheboltbutretainthenut.
2