Operator's Manual
2
Safety
1. Danger—read and
understand the
operator’s manual
before performing any
maintenance.
2. Cutting hazard of
hands or feet—stop the
engine before
approaching the reel
area.
Safety decals and instructions are easily visible to the operator and are located near any area of
potential danger. Replace any decal that is damaged or lost.
Safety and Instruction Decals
General Specifications
Part No. 93-8064 (for CE)
Part No. 67-7960
Specifications
Fully floating with hydraulic counterbalance cutting unit
suspension system provides fore and aft oscillation. Main center
pivot allows side-to-side oscillation. With optional Fixed Kit, Part
No. 93-6915, cutting units can be locked into fixed (fore/aft)
position for use with skids or anti-scalp rollers.
Height of cut
Single knob screw adjustment for bedknife to reel, located at
center of bedbar. Each notch on the knob will move the bedknife
.013mm.
Bedknife-to-reel adjustment
Suspension system
5-blade at 1040 reel RPM at 8 km/h = 25mm clip
5-blade at 1040 reel RPM at 9.7 km/h = 30.5mm clip
8-blade at 1040 reel RPM at 8 km/h = 16mm clip
8-blade at 1040 reel RPM at 9.7 km/h = 19mm clip
Frequency of clip (with variable speed set
to maximum RPM)
6mm to 44mm
13mm to 67mm with fixed cutting unit
Specifications and design subject to change without notice.