* "# () ' ! %#& $+
SPECIFICATIONS Reel Construction: $ + & +( *+ '$, ,' +)- * + , Verticutting ( & ,* ,!'& Range: Reel Diameter: ( ,' ( $ Power: 0 * -$! %','* +($!& ,' * $ + , Reel Bearings: $ $! &!& *'$$ * $$ ,0( /!, +, '-+!& Roller Adjustment: "-+, $ *'&, & * * *'$$ *+ !& IMPORTANT: Traction unit must be equipped with 27" Lift Arms, Model 03220 to accommodate 27" verticutting reels.
ADJUSTING VERTICUTTING REEL ADJUST BLADE DEPTH (Fig. 3) NOTE: * ' $ " # ! &$ & "! ! % && ! % # 3. & + ""% ! $ !'& % '$ ! $" $ $ & &" ! $ & 4. "( $# ! "&& $% ! $ $ '%& ! # !% % '$ ! $" $ %'##"$&% &" % # & % 1. & ( $& '&& ! $ "! ( %'$ 2. ' $% '! $ & $"!& ! $ $ $" $% " & ( $& '&& ! $ %'$ $ "( $% & ' ! & " $" $ 5.
! +) Loosely secure a capscrew, (2) washers, a jam nut and a locknut to each end of roller scraper as shown in figure 6. Rear scraper installation is shown in figure 6, reverse scraper so edge is on top when installing on front roller. Assure scraper rod is parallel to roller and level surface. Adjust scraper to desired position to meet turf conditions. Scraper may not need to be used in dry conditions.
Each unit has (6) grease fittings that must be lubricated regularly with No. 2 General Purpose Lithium Base Grease. The grease fitting locations and quantities are: reel bearings (2 ea.) front roller (2) and rear roller (2). Lubricating immediately after washing helps purge water out of bearings and increases bearing life. Wipe each grease fitting with a clean rag. Apply grease until pressure is felt against handle.
--)6 )2" , 1&1" 1, +21 &+01 )) +21 ,+ 0% #1 +! 1&$%1"+ 1, #1 ) &'- #)" ') 0'-# +0-" 1 " /&+$0 +! /"-) " &# 4,/+ ,/ ! * $"! "-) " ,1% " /&+$0 0 0"1 (" 02/" " /&+$ 0" 1&+$ 02/# "0 +! 1%/" !0 ,+ /"") 0% #1 "+!0 /" )" + --)6 +1& 0"&7" )2 /& +1 1, ,1% " /&+$ 0" 1&+$ 02/# "0 )&$+ /"") &+0&!" 1%" 2+&1 4&1% 1%" " /&+$ %,20&+$ %,)"0 %" /"") *201 " -,0&1&,+"! 0, 1% 1 1%" +21 "+! ,# 1%" 0% #1 )"#1 % +! 1%/" !0 &0 ,+ 1%
OPTIONAL BLADE CONFIGURATIONS ! . *," -,,"& * $ "+ +!"(( *'% ,! ,'*0 /",! +( "& ,/ & $ + ","'& $ +( *+ * . "$ $ '* ',! * +( "& '(,"'&+ ( * * $ " +"* '& " -* ,"'&+ * +!'/& $'/ 1" Spacing (Standard) )-"* + $ + ( *, &' !" # ( *+ ( *, &' " !" # ( *+ ( *, &' & Part No. 93-3092 Part No. 93-3091 Part No.
The Toro Commercial Products Two Year Limited Warranty The Toro Company warrants your 1996 or newer Toro Commercial Product (Product") purchased after January 1, 1997, to be free from defects in materials or workmanship for the period of time listed below. Where a warrantable condition exists, Toro will repair the Product at no cost to you including diagnosis, labor, parts, and transportation. This warranty begins on the date the Product is delivered to the original retail purchaser.
