Operator's Manual

Safety

Safety and Instruction Decals

Safety decals and instructions are easily visible to the operator and are located near any

area of potential danger. Replace any decal that is damaged or lost.

Part No. 93-6688 (for CE)

1. Danger—read and

understand the operator’s

manual before performing

any maintenance.

2. Cutting hazard of hands or

feet—stop the engine

before approaching reel

area.

Part No. 67-7960

Specifications

General Specifications

Height-of-cut

3/8 to 1-3/4 in. (10mm to 44mm)

1/2 to 2-5/8 in. with fixed cutting unit (13mm to 67mm)

Frequency of clip

(with variable speed set to

maximum RPM)

5 blade at 1040 reel RPM at 5 MPH=1 in. clip (8 km/h = 25mm clip)

5 blade at 1040 reel RPM at 6 MPH=1.2 in. clip (9.7 km/h = 30.5mm clip)

8 blade at 1040 reel RPM at 5 MPH=.63 in. clip (8 km/h = 16mm clip)

8 blade at 1040 reel RPM at 6 MPH=.76 in. clip (9.7 km/h = 19mm clip)

11 blade at 1040 reel RPM at 5 MPH=.46 in. clip (8 km/h = 12mm clip)

11 blade at 1040 reel RPM at 6 MPH=.55 in. clip (9.7 km/h = 14mm clip)

Bedknife to reel

adjustment

Single knob screw adjustment for bedknife to reel, located at center of bedbar.

Each notch on the knob will move the bedknife .0005 inches (.013mm).

Suspension system

Fully floating with hydraulic counterbalance. L-I-N-K-S cutting unit suspension

system provides fore and aft oscillation. Main center pivot allows side-to-side

oscillation. With optional Fixed Kit, Part No. 93-6915, cutting units can be locked

into fixed (fore/aft) position for use with skids or anti-scalp rollers.

Specifications and design subject to change without notice.