Installation Instructions

ManualsBrandsToro ManualsAttachmentsWeight Kit for 8-Blade or 11-Blade Electric DPA Cutting Unit with 5in Reel, Reelmaster 5010-H/5210/5410 Series Traction Unit

FormNo.3388-955RevA

End-WeightKitfor8-Bladeor11-Blade

DPACuttingUnitwith5inor7inReel

Reelmaster

5010-HSeriesTractionUnit

ModelNo.03405

ModelNo.03411

ModelNo.03412

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Determinethepositionoftheend-weightandreelmotors.

Weight

O-ring

Bolt10

Specialshoulderbolt(For03405and03411

modelsonly)

Installtheweightontothecuttingunits.

WARNING

CALIFORNIA

Proposition65Warning

Thisproductcontainsachemicalorchemicals

knowntotheStateofCaliforniatocausecancer,

birthdefects,orreproductiveharm.

DeterminingtheEnd-Weight

Orientation

RefertoFigure1todeterminethepositionoftheendweight

andreelmotors.

g027620

1 54

2 3

Figure1

1.#1cuttingunit5.#5cuttingunit

2.#2cuttingunit

6.Reelmotor

3.#3cuttingunit

7.End-weight

4.#4cuttingunit

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3388-955*A

Summary of content (2 pages)

PAGE 1
Form No. 3388-955 Rev A End-Weight Kit for 8-Blade or 11-Blade DPA Cutting Unit with 5in or 7in Reel Reelmaster® 5010-H Series Traction Unit Model No. 03405 Model No. 03411 Model No. 03412 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. Use No parts required – Determine the position of the end-weight and reel motors.
PAGE 2
Installing the End-Weight Install the end-weight onto the cutting unit (Figure 2). Note: Use Figure 1 to determine where to properly place end-weight. 1 g02751 1 Figure 3 1 2 3 1. Special shoulder bolt g027510 Figure 2 1. Bolt 3. O-ring 2. Counterweight Note: Torque the bolts to 36.6-44.7 N-m (27–33 ft-lbs). For hybrid machines with model numbers 03405 and 03411 only: Before installing the reelmotor, replace the shoulder bolt with a special shoulder bolt as shown in Figure 3.