Installation Instructions

FormNo.3387-155RevA

RearRollerBrushorGroomerWeightKitforDPA

CuttingUnitwith5inReel

Reelmaster

5010-HSeriesTractionUnit

ModelNo.03413

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

InstallingtheWeightKit

InstallingaWeightonaCuttingUnit

withaRearRollerBrush

1.Removethe2shortscrewsfromthetopofthebearing

housingonacuttingunit(Figure1).

2.Installaweighttothebearinghousingandsecurethe

weightwith2longscrews(Figure1).

3.Repeattheprocedureonthe4othercuttingunits.

Figure1

1.Shortscrews(existing)3.Weight(5)

2.Longscrew(10)

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3387-155*A

PAGE 1
Form No. 3387-155 Rev A Rear Roller Brush or Groomer Weight Kit for DPA Cutting Unit with 5in Reel Reelmaster® 5010-H Series Traction Unit Model No. 03413 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installing the Weight Kit Installing a Weight on a Cutting Unit with a Rear Roller Brush 1.
PAGE 2
Installing a Weight on a Cutting Unit with a Groomer 1. Remove the 2 short screws from the top of the groomer cover on a cutting unit (Figure 2). 2. Install a weight to the groomer cover and secure the weight with 2 long screws (Figure 2). 3. Repeat the procedure on the 4 other cutting units. Figure 2 1. Short screws (existing) 3. Weight (5) 2.