Service Bulletin

Customer Service Bulletin
Commercial Business Group
Reelmaster
®
2300 and 2600
Model/Serial Range: Model Number: Serial Numbers:
03421 50001-69999
03422/03427 60001-79999
03426 50001-69999
Subject: Lift Arm has excessive fore and aft movement.
Some units may develop excessive wear at the lift arm pivot pin allowing excessive
forward and rearward movement of the Lift Arms. If the lift arms become excessively
loose, install the parts shown below to reinforce this area. Parts are available through
your local Toro distributor.
3) 98-3446 Plate, Reinforcement
3) 98-3445 Spacer
3) 323-9 Screw
2) 323-18 Screw
1) 323-4 Screw
3) 32144-109 Screw
Instructions
1. Raise cutting units and disconnect all counterbalance springs.
2. Lower cutting units to ground and remove ignition key.
3. Remove and discard three original fasteners shown below.
4. Install new fasteners through Reinforcement Plate and Spacer as illustrated.
Note: Mount the short side of the reinforcement plate onto the pivot pin.
5. Raise cutting units and install counterbalance components.
Ref: 15-05 Copyright

, 1998. The Toro Company
Spacer 98-3445
Reinforcement
Plate 98-3446
Capscrew 323-18 (front)
Capscrew 323-4 (rear)
Capscrew 323-9
Capscrew 32144-109