Operator's Manual

13
Setup
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts,
total setup cannot be completed. Some parts may have already been assembled at the factory.
Description Qty. Use
Wheel assembly
Lug nut
1
4
Installing the rear wheel
Seat stop bracket
Capscrew 5/16 x 1 in.
Locknut
1
1
1
Mount seat stop
Flat washer
Capscrew
Locknut
3
3
3
Mounting the carrier frames to the cutting units.
Lift arm
Pivot rod
Capscrew, 5/16 x 7/8 in.
Lock washer
Lift chain
Clevis pin
Cotter pin
2
2
2
2
2
4
4
Installing the front lift arms (supplied with the
Lift Arm Kit)
Thrust washer
Flat washer
Flange head capscrew
3
3
3
Mounting the cutting units to the lift arms
(supplied with the Lift Arm Kit)
Spring
Vinyl sleeve
Spring shackle
Clevis pin
Cotter pin
3
1
3
6
6
Installing the counterbalance springs (supplied
with the Lift Arm Kit)
Shackle
Spring anchor
Capscrew, 1/4 x 3/4 in.
Locknut
2
2
4
4
Installing the counterbalance springs (supplied
with the 32” Cutting Unit Lift Arm Kit only)
Key 2
Hydraulic reservoir plug 1
Danger decal 1
Affix to inside of right hand panel housing for
European compliance.
Warning decal 1 Affix to skirt for European compliance.
Danger decal 1 Affix to battery for European compliance.