Operator's Manual

14
Description UseQty.
Instrument panel decal 1
Affix to instrument panel for European
compliance.
Parts catalog
Certificate of compliance
1
1
Operator video 1 View before operating the machine.
Operator’s manual
Engine operator’s manual
2
1
Read before operating the machine.
Registration card 1 Fill out and return to Toro.
Installing the Rear Wheel
1. Mount the wheel assembly onto the rear wheel hub
(Fig. 1).
1
2
3
Figure 1
1. Wheel assembly
2. Rear wheel hub
3. Lug nut
2. Install the lug nuts (Fig. 1) and tighten them to 45–65
ft.-lb. (3–5 N⋅m).
Installing the Seat
The traction unit is shipped without the seat assembly.
Suspension Seat Kit, Model 03225, or Standard Seat Kit,
Model 03224, must be installed as follows:
Important When installing seat, do not install seat
belt. Remove and discard.
1. Remove the shipping ties securing the lower seat slides
to the upper seat slides. Note the orientation of the
lower slides for correct reinstallation (Fig. 2).
2. Insert the lower slides onto the upper slides (Fig. 2).
3. On the Suspension Seat, check the alignment of the
mounting holes with the seat plate. If the holes do not
align, remove the machine screws securing the upper
slides to the seat bottom. Move the seat slides inward to
the next set of mounting holes and secure them with the
machine screws and 4 locknuts (M8). Apply Loctite to
the fasteners.
1
2
3
Figure 2
1. Lower seat slide
2. Upper seat slide
3. Seat plate
4. Loosely secure slides to seat plate with fasteners
supplied with seat (Fig. 2).