Operator's Manual

Greasing the Bearings and

Bushings

The traction unit has grease fittings that must be lubricated

regularly with No. 2 General Purpose Lithium Base Grease.

If the machine is operated under normal conditions,

lubricate bearings and bushings after every 50 hours of

operation. Bearings and bushings must be lubricated daily

when operating conditions are extremely dusty and dirty.

Dusty and dirty operating conditions could cause dirt to get

into the bearings and bushings, resulting in accelerated

wear.

The traction unit bearings and bushings that must be

lubricated are: steering column (Fig. 38), steering gears (2)

(under the skirt below the steering sector), steering shaft (2)

(Fig. 39), lift arms (3) (Fig. 40), rear lift cylinder pivot

(Fig. 40), pivot rods (3) (Fig. 41), traction pedal pivot

(Fig. 42) and neutral centering (Fig. 43)

Also, apply grease to slots in cylinder support (Fig. 44).

Figure 38

Figure 39

Figure 40

Figure 41

Figure 42