Installation Instructions

ManualsBrandsToro ManualsRiding ProductsThree-Wheel Drive Kit, Reelmaster 2000-D

Printed in the USA

 2003 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Three-Wheel Drive Kit

Reelmaster



2000

Model No. 03429

Form No. 3329–851

Installation Instructions

1. Park the traction unit on a level surface, set the parking

brake and stop the engine. Remove the key from the

ignition.

If you leave the key in the ignition switch, someone

could accidently start the engine and seriously

injure you or other bystanders.

Remove key from ignition switch before you do

any maintenance.

Caution

2. Lift the rear of the traction unit and remove the lug nuts

securing the tire assembly to the wheel hub (Fig. 1).

Retain the lug nuts.

Figure 1

1. Tire assembly

2. Wheel hub

3. Castor fork

3. Remove the bolts and nuts securing the wheel hub

assembly to the castor fork (Fig. 1). Discard the wheel

hub assembly but retain the bolts and the nuts.

4. Mount (2) straight hydraulic fittings to the side of the

new wheel motor (Fig. 2).

5. Mount the 45 fitting ends of the hydraulic hose

assemblies to the straight fittings on the motor (Fig. 2).

Note: Make sure all the O–rings are lubricated and in

position before installing the fittings.

6. Mount the motor assembly to the castor fork with the

(4) bolts and nuts previously removed. Position the

motor assembly as shown in figure 2.

7. Mount the tire assembly to the motor and hub assembly

with the (4) lug nuts previously removed. Torque the

lug nuts to 70 to 90 ft.-lb (95 to 122 N⋅m).

Figure 2

1. Wheel motor assembly

2. Straight fitting

3. Hydraulic hose assembly

8. Lower the rear of the traction unit to the ground.

9. Disconnect the negative cable and then positive cable

from the battery.

10. Remove the seat, if installed.

Summary of content (4 pages)

PAGE 1
Form No. 3329–851 Three-Wheel Drive Kit Reelmaster 2000 Model No. 03429 Installation Instructions 4. Mount (2) straight hydraulic fittings to the side of the new wheel motor (Fig. 2). 1. Park the traction unit on a level surface, set the parking brake and stop the engine. Remove the key from the ignition. 5. Mount the 45 fitting ends of the hydraulic hose assemblies to the straight fittings on the motor (Fig. 2).
PAGE 2
11. Remove the (4) carriage bolts and nuts securing the skirt assembly to the frame (Fig. 3). Also, remove the capscrew securing the skirt to the fuel filter bracket. 14. Route the wheel motor hydraulic hose assemblies along the left side of the frame and secure them to the fittings on the rear of the selector valve (Fig. 5) as follows: • The top hose from the wheel motor to the outside fitting on the selector valve. • The bottom hose from the wheel motor to the inside fitting on the selector valve.
PAGE 3
17. Clean the area around the caps on hydraulic tubes (Fig. 7). 1 Figure 7 1. Caps 18. Place a drain pan under hydraulic tubes and remove the caps. Figure 9 Note: Make sure all the O–rings are lubricated and in position before installing lines. 21. Mount the skirt to the traction unit frame with the (4) carriage bolts and nuts previously removed. Also, secure the skirt to the fuel filter bracket with the capscrew previously removed. 19.
PAGE 4