Installation Instructions

FORM NO. 3319-167

The TORO Company - 1996

TPS

INSTALLATION

INSTRUCTIONS

PART NO. 94-5080

FULL ROLLER SCRAPER KIT

For Reelmaster 2600D

CAUTION

Before servicing or making adjustments to the

machine, stop engine and remove key from

the switch.

1. Loosely secure a capscrew, (2) washers, a jam nut

and a locknut to each end of roller scraper as shown in

figure 1.

Note: Scraper can be mounted to back side of front or

rear roller.

2. Thread each capscrew into roller brackets until

desired clearance between scraper and roller is

attained. Make sure scraper is parallel to roller.Tighten

locknuts securing scraper to capscrews and jam nuts

securing scraper to roller.

Figure 1

1. Capscrew

2. Washer

3. Scraper

4. Jam nut

5. Locknut