FORM NO. 3317-945 Rev. A MODEL NO. 03505 — 60001 thru 70001 & UP OPERATOR’'S MODEL NO. 03508 ~ 60001 thru MANUAL 70001 & UP 5 BLADE & 8 BLADE CUTTING UNITS For Reelmaster® 5100D/5300D Traction Units © The TOR COMPANY — 1995, Rev.
TABLE OF CONTENTS Page No. SPECIFICATIONS 2 KNOWYOURCUTTINGUNIT 2 ADJUSTING CUTTING UNIT .. Adjusting Bed knife to Reel Adjusting Shield Height . 3 Adjusting Top Bar Leveling Front Roller to Reel . Adjusting . .. BACKSLAPPING CUTTING UNIT 4 Page No.
ADJUSTING CUTTING UNIT 3. After the adjustments accomplished, check to see if reel can pinch paper when inserted from the front and cut paper when inserted at a right angle {Fig. 2). It should be possible to cut paper with minimum contact between the bed knife and the reel blades. Should excessive reel drag be evident it will be necessary to either back lap or re—grind the cutting unit to achieve the sharp edges needed for precision cutting (see Toto reel sharpening manual).
ADJUSTING CUTTING UNIT NOTE: Bar is adjustable to compensate for changes in turf conditions. Bar should be parallel to reel to assure optimum performance end should be adjusted whenever shield height is adjusted or whenever reel is sharpened on a reel grinder. LEVELING FRONT ROLLER TO REEL 1. Adjust rear roller assembly to lowest height—of —cut, refer to section on Adjusting Height of Cut. Do not tighten nuts securing height of cut brackets at this time. 2.
BACKSLAPPING CUTTING UNITS A DANGER REELS MAY STALL WHILE BACKSLAPPING. DO NOT ATTEMPT TO RESTART REELS BY HAND OR ADJUST WHILE BACKSLAPPING. SET SPEED CONTROL TO POSITION 11 TO START REELS; SET TO POSITION 1 FOR BACKSLAPPING. Mote: Back lap either the front cutting units together or the rear ones together. 1. Position making on a clean, level surface, lower the cutting units, spat the engine, engage the parking brakes, move enable/disable switch to disable position and remove key from ignition switch. 2.
MAINTENANCE IMPORTANT: Reel motors must be removed before removing the cutting units to prevent hose damage due to twisting, bending, and kinking. REMOVING BED KNIFE FOR GRINDING The rear roller assembly must be removed in order to remove the bed knife assembly for sharpening. To remove the rear roller, proceed as follows: 1. Remove cap screw and nut anchoring the rear roller bracket to the side plate on both ends of the cutting unit (Fig. 9). 2.
MAINTENANCE C. Hals the reel from turning and slowly tighten the reel bearing adjustment nut until no end play of the reel exists. D. Using an appropriate torque wrench, check the rolling torque of the reel. The rolling torque of the reel should Check to make sure no end play exists and reel spins freely. E. Reinstall the counterbalance end cap. Figure 10 1. Heel Bearing Housing 2.
The Toto Promise A One Year Limited Warranty The Torah Company promises to repair your TOR product if defective in materials or workmanship. h The following time periods from Commercial Products e date of purchase apply: The cost of parts, labor and transportation are included. I you feel your TOR Product is defective and wish to Some states do not allow limitations on how long rely on The Toto Promise, the following procedure is an implied warranty lasts, so the above limitation recommended: 1.
