Operator's Manual

Note: As the dethatcher blades wear, the diameter of

the reel will decrease, and the positive or negative

setting will change. Check the height setting

periodically to insure the desired setting is achieved.

Figure 3

1. Front grass shield

2. Front grass shield screws

3. Rear grass shield

4. Rear grass shield screws

Adjusting Rear Grass Shield

(Fig. 3)

Note: When operating in turf conditions where much

debris is encountered, or unusually heavy thatch,

open the rear discharge shield to help allow the debris

to discharge from the reel.

1. Loosen the capscrew on the right side of the

dethatcher reel, located on the pivot of the rear

grass shield (Fig. 3).

2. Rotate the rear grass shield to the desired setting

and tighten the capscrew.

Adjusting Front Roller Scraper

(Fig. 4)

1. Loosen the (2) capscrews securing front roller

scraper to brackets. Slide front roller scraper to

ensure the teeth of scraper are centered between

the disks of the front wiehle roller (Fig. 4).

Figure 4

1. Front roller scraper 2. Roller bracket

2. Retighten capscrews securing roller scraper to

front roller scraper brackets.

Adjusting Rear Roller Scraper

(Fig. 5)

1. Thread jam nuts in or out on capscrews until

scraper makes slight contact with roller and is

parallel to roller.

Figure 5

1. Rear roller scraper 2. Jam nuts

2. Secure scraper at desired height on roller by

tightening jam nuts. Recheck setting.

Note: Adjust scraper to desired position to meet turf

conditions.