Operator's Manual

4
Specifications
Reel Construction: Fairway reels. 5 & 8 blades welded
construction.
Recommended Height–of–Cut Range:
5 Blade – 5/8” to 1” (13–25 mm)
8 Blade – 1/4” to 5/8” (6–16 mm)
Reel Diameter: 5 in (127 mm)
Reel Bearings: Taper roller bearings.
Power Attachment: Hydraulic motor splined to reel
shaft. Reel motors feature quick disconnect for removal
or installation onto cutting unit.
Bedknife and Bedbar adjustment: Opposing fine thread
screws.
Height–of–Cut & Roller Adjustment:
Front: 3 fixed positions for setting cutting unit attitude.
Optional Adjustable Front Height Of Cut kit, part no.
104–8205, allows for variable adjustment to cutting unit
attitude with adjustable height of cut rods, within the
height of cut range of 1/4” to 1 3/8”.
Rear: Screw adjustable with bolt clamp lock used for
setting height of cut.
Selected Clip Control: The Reelmaster 5000 traction unit
is equipped with manually adjustable reel speeds (275 rpm
to 2000 rpm) which control selected clip.
Note: Refer to Traction Unit Operator’s Manual for
proper set–up procedure
Rollers: Front roller is a 3” (76 mm) diameter cast Wiehle
roller. Rear roller is a 2.5” (64 mm) diameter steel full
roller. Both rollers use heavy duty ball bearings with two
conventional single lip seals and a Toro labyrinth seal to
provide four sealing surfaces to protect the bearings.
Optional Equipment:
Dethatching Cutting Unit Model No. 03516
Grass Basket Kit (5) Model No. 03532
Rear Roller Brush Kit Model No. 03533
Comb kit Part No. 104–3385
Adjustable Front H.O.C kit Part No. 104–8205
Wiehle Roller Scraper Part No. 104–3380–03
Rear Roller Scraper kit Part No. 104–3395
Shoulder Roller Part No. 104–3369
Shoulder Roller Scraper Part No. 104–8208–03
Heavy Duty Bedknife Part No. 100–3350
(for height of cut above 1/2” (13mm)
3” Collar Kit Part No. 104–8215
Gauge Bar Assembly Part No. 98–1852
Angle Indicator Part No. 99–3503
Backlapping Brush Assembly Part No. 29–9100
Bedknife Screw Tool Part No. TOR510880