Operator's Manual

Set–Up

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Note: Use the chart below to verify all parts have been shipped.

DESCRIPTION QTY. USE

Decal 1 Apply over existing decal for CE

Operator’s Manual 1 Read before operating machine.

Parts Catalog 1 Use for ordering replacement parts.

Registration Card 1 Fill out and return to Toro.

Inspection

After the cutting unit is unboxed, inspect the

following:

1. Check for looseness in the bearings between the end

plate and reel. Check for looseness of bearings by

moving reel laterally or axially on each end of cutting

unit, refer to section on Servicing and Adjusting the

Reel Bearings.

2. Check each end of the reel for grease. Grease should

be visibly evident in the reel bearings and internal

spline of reel shaft end.

3. Ensure that all nuts and bolts are securely fastened.

4. Make sure carrier frame suspension operates freely and

does not bind when moved back and forth.

Adjusting Front Shield

Adjust front shield for desired grass clippings

dispersion and filing of baskets.

1. Position cutting unit on a flat level surface.

2. Loosen capscrews and nuts securing shield to each

side plate. Move shield to desired angle and tighten

fasteners (Fig. 2).

Figure 2

1. Front grass shield 2. Capscrew & nut

Adjusting Rear Shield

Under most conditions, best dispersion is attained

when rear shield is closed (front discharge). When

conditions are heavy or wet, rear shield may be

opened.

1. To open rear shield (Fig. 3), loosen flange head

capscrew securing shield to right side plate, rotate

shield to open position and tighten capscrew.