Operator's Manual

Figure 3

1. Rear grass shield

mounting capscrew

Adjusting Cut–Off Bar

The Cut–Off bar is designed to keep the gap between the

reel and the Cut–Off minimal to insure grass clippings

discharge cleanly from reel area.

Note: The gap between the Cut–Off bar and reel will

increase as: 1) the reel wears, 2) reel is sharpened by

grinding, or 3) if the front grass shield is adjusted.

1. Loosen screws securing Cut–Off bar (Fig. 4). Insert

0.060” (2 mm) feeler gauge between top of reel and

Cut–Off bar.

Figure 4

1. Cut–off bar 2. Screw (4)

2. Ensure gap is set equally across reel, and retighten

screws.