Service Manual

Rev. E

Reelmaster 5200-D/5400-DHydraulic System Page 4 - 70

2. Apply grease or petroleum jelly to ring seal and install

on body.

3. Apply hydraulic oil to inside of cover and assemble

the cover to the body, making sure none of the parts be-

come displaced. Insert the cap screws and washers and

hand tighten.

4. Before tightening the cap screws, rotate the drive

shaft in the direction of normal rotation (counterclock-

wise) to c heck for binding. You may not be able to rotate

the drive shaft by hand. Protect the shaft if using a pliers.

5. Tighten the cap screws evenly in a crossing pattern

to a torque of 17 ft-lb (23 N-m).

6. Carefully install a new spacer, shaft seal and snap

ring (see Shaft Seal Installation).

Reel Motor (Serial Number Above 230000000)

1. Rear cover

2. Drive gear

3. Seal

4. Tab washer

5. Pressure seal

6. Back--up ring

7. O--ring

8. Body

9. Idler gear

10. Cap screw

11. Front flange

12. Washer (if equipped)

Figure 92

(24to32Nm)

215 to 280 in--lb