Service Manual

Reelmaster 5200-D/5400-D Page 5 - 15 Electrical Systems (Rev. D)

Component Testing

For accurate resistance and/or continuity checks, elec-

trically disconnect the component being tested from the

circuit (e.g. unplug the ignition switch connector before

doing a continuity check).

NOTE: For more component testing information, see

the Kubota Workshop Manual, Diesel Engine, 05 Series

at the end of Chapter 3 - Kubota Diesel Engines.

CAUTION

When testing electrical components for continu-

ity with a multimeter (ohms setting), make sure

that power to the circuit has been disconnected.

Ignition Switch

The ignition (key) switch has three positions (OFF, RUN,

and START). The terminals are marked as shown. The

circuit wiring of the ignition switch is shown in the chart.

With the use of a multimeter (ohms setting), the switch

functions may be tested to determine whether continuity

exists between the various terminals for each position.

Verify continuity between switch terminals.

POSITION

CIRCUIT

OFF NONE

RUN B + I + A, X + Y

START B + I + S

Figure 11

1. Key

2. Hex nut

3. Lock washer

4. Ignition switch

Electrical

System