Service Manual

Reelmaster 5200-D/5400-DPage 5 - 32Electrical Systems (Rev. D)

Joystick Raise and Lower/Mow Switches

Two micro switches for the joy stick are located on the

lift control mechanism that is inside the control console.

The rear switch on the mechanism is used to lower the

reels and the front switch to raise them. A normally open

contact closes when the joy stick is positioned to either

to lower or raise the reels. Each switch has a electrical

connector to make sure the normally closed contact on

the switch is not used. The raise switch has violet and

black wires connected to it and the lower switch has pink

and black wires.

1. Joy stick

2. Micro switch

3. Lift control mechanism

Figure 48

Unit Serial No.

80001-209999999

Unit Serial No.

210000001 & Up

Front Reels Down Sensor

The sensor consists of two parts. The reed switch is lo-

cated on the left end of the carrier frame and has a nor-

mally open contact. The switch actuator is located on the

left lift arm and is made of a magnetic material. When the

front reels are lowered, the magnetic field of the actuator

is positioned near the reed switch, and the contact in the

switch closes. The switch has a electrical connector at-

tached to the carrier frame.

1. Reed switch

2. Switch actuator

3. Carrier frame

4. Lift arm (LH)

Figure 49