Service Manual

Rev. A
Reelmaster 5200-D/5400-DSteering and Brakes Page 7 - 16
Installation
1. Install the steering cylinder as follows:
A. (2WD) Hold the steering cylinder in position and
install the lock nut and cap screw securing the barrel
end of the cylinder to the rear axle (Fig. 17).
B. Install the lock nut and cap screw securing the rod
end of the cylinder to the steering pivot.
C. Tighten the cylinder mounting cap screws and
nuts to 130 to150 ft-lbs. (176 to 203 Nm).
A. (4WD Unit Serial No. 80001 - 99999) Hold the
steering cylinder in position and install the pivot pin
and thrust washers (Fig. 18). Use medium strength
Loctite thread locker and tighten the capscrew to 70
to 80 in-lbs. (8 to 9 Nm).
B. Install the lock nut, capscrew, and thrust washers
securing the rod end of the cylinder to the steering
arm. Tighten the cylinder capscrew and nut to 130
to150 ft-lbs. (176 to 203 Nm)
A. (4WD Unit Serial No. 200000001 & Up) Hold the
steering cylinder in position and install the retaining
ring securing the barrel end of the cylinder to the cyl-
inder mounting bracket (Fig. 19).
B. Install the retaining ring securing the rod end of
the cylinder to the bevel gear case.
2. Connect hydraulic hoses. Bleed the hydraulic sys-
tem and check hydraulic connections for leaks (see
Chapter 4−Hydraulic System “Bleeding the Hydraulic
System” in this manual).