Service Manual

Rev. A
Cutting Units
(Model 03527, S/N 210000001 & Up)
(Model 03528, S/N 210000001 & Up)
Reelmaster 5200-D/5400-DPage 8.1 - 2
Specifications
Figure 1
REEL CONSTRUCTION: Fairway reels. All welded. 5
or 8 blades.
HEIGHT OF CUT RANGE:
5 Blade - 5/8” to 1” (13-25 mm)
8 Blade - 1/4” to 5/8” (6-16 mm)
Note: Heavy duty bedknife Part No. 100-3350 available
for height-of-cuts over 1/2” (13 mm).
REEL DIAMETER: 5 in. (127 mm)
REEL BEARINGS: Taper roller bearings
POWER: Hydraulic motor splined to reel shaft. Reel mo-
tors feature quick disconnect for removal or installation
onto cutting unit.
BEDKNIFE AND BEDBAR ADJUSTMENT: Opposing
fine thread screws
HEIGHT−OF−CUT & ROLLER ADJUSTMENT:
Front: 3 fixed positions for setting cutting unit attitude.
Optional Adjustable Front Height Of Cut kit, part no.
104−8205, allows for variable adjustment to cutting unit
attitude with adjustable height of cut rods, within the
height of cut range of 1/4” to 1 3/8”.
Rear: Screw adjustable with bolt clamp lock used for
setting height of cut.
Selected Clip Control: The Reelmaster 5200/5400 is
equipped with manually adjustable reel speeds (275
rpm to 2000 rpm) which control selected clip.
Rollers: Front roller is a 3” (76 mm) diameter cast
Wiehle roller. Rear roller is a 2.5” (64 mm) diameter
steel full roller. Both rollers use heavy duty ball bearings
with two conventional single lip seals and a Toro laby-
rinth seal to provide four sealing surfaces to protect the
bearings.
OPTIONS & KITS:
Basket Kit (3 baskets) Model 03532
Rear Roller Brush Kit Model 03533
Wiehle Roller Scraper Part No. 104-3380-03
Rear Roller Scraper Kit Part No. 104-3395
Shoulder Wiehle Roller Part No. 104-3369
Shoulder Wiehle Scraper Part No. 104-8208-03
Comb Kit Part No. 104-3385
Adjustable Front H.O.C. kit Part No. 104-8205