Service Manual

Cutting Units
Model 03527 & 03528
Rev. E
Reelmaster 5200-D/5400-D Page 8.1 - 3 Cutting Units
(Model 03527, S/N 210000001 & Up)
(Model 03528, S/N 210000001 & Up)
Special Tools
Order special tools from your Toro Distributor. Some tools may have been supplied with your machine
or be available as TORO parts. Some tools may also be
available from a local supplier.
Gauge Bar Assembly
Use gauge bar to verify height of cut and bedknife atti-
tude.
Toro P/N 98-1852
Used only with
Adjustable Front Height of Cut Kit
Figure 2
Angle Indicator
Use with Gauge Bar Assembly to verify bedknife atti-
tude.
Toro P/N 99-3503
Figure 3
Bedknife Screw Tool - TOR510880
This screwdriver-type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a torque wrench to se-
cure the bedknife to the bedbar. Make sure bedbar
threads are clean and use new screws. Tighten screws
to a torque of 250 - 300 in.lb. (28 - 34 Nm) starting in the
middle of the bedknife (Fig. 34).
NOTE: Remove all rust, scale and corrosion from bed-
bar surface before installing bedknife.
DO NOT use and air impact wrench with this tool.
Figure 4