Service Manual

Reelmaster 5200-D/5400-D Page 3 - 17 Kubota Diesel Engines
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Open engine hood on the machine.
CAUTION
Do not open radiator cap or drain coolant if the
radiator or engine is hot. Pressurized, hot cool-
ant can escape and cause burns. Ethylene-gly-
col antifreeze is poisonous. Dispose of coolant
properly, or store it in a properly labeled contain-
er away from children and pets.
3. Drain radiator into a suitable container using the ra-
diator drain. Disconnect hoses from the radiator.
4. Remove front housing screen from the radiator sup-
port. Disconnect hose from the vent tube.
5. Detach both oil coolers and fan shroud from the ra-
diator.
6. Remove four cap screws, flat washers and lock
washers securing the radiator support to the frame. Pull
radiator and support from the frame.
7. Plug any openings to prevent contamination.
Installation
1. Remove any plugs used during the removal proce-
dure.
2. Position radiator and support to the frame. Secure
radiator support and radiator to the frame with four lock
washers, flat washers, and cap screws.
3. Attach both oil coolers and fan shroud to the radiator.
4. Connect hose to the vent tube. Install front housing
screen to the radiator support.
5. Connect hoses to the radiator.
6. Make sure radiator drain is closed. Fill radiator with
fluid (see Check Cooling System).
7. Close engine hood to the machine.
Kubota Diesel
Engines