Service Manual

Reelmaster 5200-D/5400-D Hydraulic SystemPage 4 - 41

Replace Hydraulic Oil Filter

The hydraulic system filter head is equipped with a ser-

vice interval indicator. With the engine running, view the

indicator, it should be in the GREEN zone. When the in-

dicator is in the RED zone, the filter element should be

changed.

IMPORTANT: Use the Toro replacement filter (Part

No. 75-1310). Use of any other filter may void the

warranty on some components.

1. Position machine on a level surface, lower the cut-

ting units, stop the engine, engage the parking brakes

and remove key from ignition switch.

2. Clean area around filter mounting area. Place drain

pan under filter and remove filter.

3. Lubricate new filter gasket and fill the filter with hy-

draulic fluid.

4. Assure filter mounting area is clean. Screw filter on

until gasket contacts mounting plate. Then tighten filter

one-half turn.

1. Hydraulic filter 2. Hydraulic manifold block

Figure 34

5. Start engine and let run for about two minutes to

purge air from the system. Stop the engine and check for

leaks.

Hydraulic

Systems