Service Manual

Reelmaster 5200-D/5400-DHydraulic System Page 4 - 46
8. Install transmission control linkage to the transmis-
sion (see Transmission Control Linkage Installation).
9. Secure suction line to top of in-line filter (Fig. 38).
10.Install two (2) rear cutting units (see Chapter 8 - Cut-
ting Units).
11. Install a new filter and fill differential with correct oil.
12.Disconnect fuel stop solenoid electrical connector on
engine to prevent engine from starting. Prime transmis-
sion by turning ignition key s witch to crank engine for 10
seconds. Repeat cranking procedure again.
13.Start the engine and let it idle for approximately two
minutes. Operate machine slowly in forward and re-
verse. Stop engine and check differential oil level.
Check transmission for leaks.