Service Manual

Reelmaster 5200-D/5400-D Hydraulic SystemPage 4 - 51
15.Slide pump shaft and bearing assembly from hous-
ing. Press shaft out of bearing (Fig. 54).
16.Remove hex tapping screws r etaining the trunnion
seal cover and trunnion cover to housing. Mark position
of covers for reassembly. The trunnion seal cover as-
sembly includes an O-ring, lip seal, and trunnion bearing
on the control side. The trunnion cover assembly in-
cludes an O-ring and trunnion bearing on the side oppo-
site the control. Remove these parts from the housing
(Fig. 55).
17.Tilt and lift swashplate from housing (Fig. 56).
Figure 54
Figure 55
Figure 56
Hydraulic
Systems