Operator's Manual

16
Mounting the Hood Latch
1. Remove plug from hole in left front corner of hood
(Fig. 3).
2. Open the hood.
1
Figure 3
1. Hood plug
3. Mount locking latch to hood with lock washer and nut.
Position switch with latch toward front of machine
(Fig. 4).
4. Loosely mount latch strap to radiator support with 2
capscrews (1/4 x 3/4 inch), flat washers and locknuts
(Fig. 4).
2
1
3
Figure 4
1. Locking latch
2. Latch bracket
3. Latch strap
5. Adjust latch bracket, until aligned with locking latch,
then tighten capscrews.
6. Rotate latch to locked and unlocked position with key.
Remove key and store in memorable place (Fig. 4).
7. Close the hood.
Replacing the Floor Panel
Fastener
(Required for CE)
1. Remove fastener securing left front corner of floor
panel to frame (Fig. 5).
2. Replace with a flange head capscrew (5/16 x 5/8 inch)
supplied in loose parts (Fig. 5).
1
Figure 5
1. Floor panel
Checking the Tire Pressure
The tires are over–inflated for shipping. Therefore, release
some of the air to reduce the pressure. Correct air pressure
in the front and rear tires is 10-15 psi.
Important Maintain even pressure in all tires to assure
uniform contact with turf.
Installing the Cutting Units
Cutting unit models 03860, 03861, and 03862 can be
installed at any of the five mounting locations on the
traction unit.
Figure 6 shows the orientation of the hydraulic drive motor
for each of the five locations. For any of the locations
requiring the motor to be mounted on the right end of the
cutting unit, install a counter weight on the left end of the
cutting unit. For the locations requiring the motor to be
mounted on the left end, install a counter weight on the
right end of the cutting unit.