Service Manual

Reelmaster 5500-DHydraulic System (Rev. C) Page 4 - 74

Reel Motor Service

Use seal protector tool

TOR4072 when inserting

shaft through seal.

NOTE: Seal protector tool is

part of TOR4070 Cutting Unit

Tool Kit shown in Chapter 8 -

Cutting Units.

40 to 45 ft−lb

(54 to 61 N−m)

Figure 87

1. Retaining Ring 4. E-Seal 7. Valve Block

2. Shaft seal 5. O-Ring 8. Adjusting valve

3. Flange 6. Dowel pin

Removal

1. Park machine on a level surface, lower cutting units,

stop engine, engage parking brake, and remove key

from the ignition switch.

2. Disconnect hydraulic lines. Put caps or plugs on fit-

tings and hoses to prevent contamination. Tag hydraulic

lines for proper reassembly.

3. Loosen motor mounting nuts (Fig. 88).

4. Rotate motor clockwise so motor flanges clear studs

and pull motor out.

Installation

1. Place motor into position on mounting studs. Rotate

motor counterclockwise so motor flanges lock to studs.

2. Tighten motor mounting nuts

3. Remove caps or plugs from fittings and hoses. Con-

nect hydraulic lines lines to the motor.

1. Reel motor 2. Motor mounting nut

Figure 88